水泵采购网

进口离心风机美国阿卡迪亚品牌

进口离心风机Product Description:

The pull rod bolt of the impeller, including the pull rod bolt, is successively provided with a first thread, a boss and a second thread along the length direction of the pull rod bolt, the first thread and the second thread are respectively arranged at the two ends close to the pull rod bolt, and the end of the pull rod bolt close to the second thread forms a tail cone angle bayonet. The bottom of the thread groove of the motor spindle used to install the second thread end is provided with a conical bulge which is adapted to the taper angle bayonet on the tail of the pull rod bolt. The rotation direction of the first thread and the second thread is opposite to the rotation direction of the impeller. The boss protrudes from the surface of the pull rod bolt along the circumferential direction of the pull rod bolt and fits with the inner hole of the impeller. The design scheme can reinforce the connection between the centrifugal impeller and the main shaft of the high-speed motor, and is convenient for disassembly and assembly.

进口离心风机characteristic:

High speed motor direct drive centrifugal fan is widely used in petrochemical, metallurgical, environmental protection, electric power, pharmaceutical, food and other fields due to its advantages of high efficiency, energy saving, low noise, oil-free gas transmission, small unit floor area, long continuous operation cycle and convenient installation, maintenance and use.

进口离心风机Structure:

At present, according to different parameters such as medium, flow and pressure rise, such units can generally operate at a high-efficiency speed of 500030000r/min. Its main structural feature is that the impeller is directly installed on the main shaft of the high-speed motor, eliminating the structure of the bearing box and gear box of the traditional fan, making the unit efficiency about 15 ? 30% higher than the traditional unit, and the structure is compact.

Principle:

The pull rod bolt is screwed with the threaded hole of the motor main shaft through the second thread, and is installed in place by using the tail cone angle bayonet and cone convex. Then the impeller passes through the pull rod bolt, and is guided by the pull rod bolt. The middle boss of the pull rod bolt is in a transitional fit with the inner hole of the impeller. Then the hydraulic tensioner starts to work, and the lock nut is tightened under the action of bolt pre tightening force after pre stretching, The lock nut is matched with the first thread of the pull rod bolt head to fix and limit the impeller.

(仅供参考)