水泵采购网

进口环式真空泵美国阿卡迪亚品牌

进口环式真空泵Product description:

Compressor unit, including gas-liquid separator, water ring vacuum pump, heat exchange barrel, and the heat exchange barrel is installed with a rotating shaft. At least one hollow disk is fixed on the rotating shaft, and the outer side of the hollow disk is evenly distributed with arc-shaped guide tubes. The top of the rotating shaft is fixed with a rotary joint, the top of the rotary joint is fixed with a coolant inlet pipe, and the outer side of the guide tube is equipped with a spiral heat exchange coil along the vertical direction, The upper end of the spiral heat exchange coil 1 is connected with the liquid outlet of the gas-liquid separator through the infusion pipe, the lower end of the spiral heat exchange coil 1 is connected with the liquid inlet pipe of the water ring vacuum pump, the outer side of the spiral heat exchange coil 1 is provided with a spiral heat exchange coil 2 along the vertical direction, the lower end of the spiral heat exchange coil 2 is connected with an air inlet pipe, the upper end of the spiral heat exchange coil 2 is connected with an air delivery pipe, and the air delivery pipe is connected with a filter. The water ring vacuum pump can be cooled for the second time, and the gas can be filtered after cooling to protect the water ring vacuum pump and increase the service life of the water ring vacuum pump.

进口环式真空泵characteristic:

The closed circulation of working fluid of the ring vacuum compressor unit means that the gas water separator is connected at the air outlet of the water ring vacuum pump, and the liquid separated from the gas water separator is cooled by the heat exchanger and then recycled to the water ring vacuum pump, which can save water. However, the inlet air of the current ring vacuum compressor unit often contains high temperature. If it is not cooled and directly enters the water ring pump, it is easy for the water ring pump to work at a high temperature, It is not conducive to the use of the water ring pump. In addition, the pumped gas will contain impurities, and it is easy to damage the water ring pump if not fully filtered.

进口环式真空泵Principle:

By setting up a heat exchange barrel, two layers of spiral heat exchange coils are set in the heat exchange barrel, and then a guide pipe and a flow limiting pipe are set inside the inner spiral heat exchange coil to spray coolant, the coolant entering the heat exchange box can be fully exchanged with the spiral heat exchange coil. The bottom of the gas-liquid separator for heat exchange of the inner spiral heat exchange coil enters the liquid in the water ring vacuum pump, and the outer spiral heat exchange coil enters the gas in the water ring vacuum pump for heat exchange, In this way, the water ring vacuum pump can be cooled for the second time, and the gas will be filtered after cooling to protect the water ring vacuum pump and increase the service life of the water ring vacuum pump.

（仅供参考）